This DIY brass toilet paper holder is going to thrill you. Not only is it the easiest, fastest DIY in perhaps the entire history of DIYs to complete, but it’s also one of the most rewarding end results.
Materials Needed:
Note: All materials were purchased from this online retailer; item numbers are included for your convenience.
a – Flange with slip through center hole, unfinished brass (FL1) *Note: This piece is recommended for a vertical installation but isn’t needed for a horizontal installation.
b –3” long round hollow pipe with male threaded ends, 3/8” outer diameter, unfinished brass (PIBR03-0X8)
c –6” long round hollow pipe with male threaded ends, 3/8” outer diameter, unfinished brass (PIBR06-0X8)
d –Short flat bracket cap, unfinished brass (FI1450)
e –3/4″ 90 degree threaded straight armback, unfinished brass (AB472)
f – Flange with threaded center hole, unfinished brass (FL2F)
Not shown: Three (3) brass wood screws for mounting
